|
|
Journal of Global Positioning Systems Vol. 11, No. 2, 2012 |
Cover |
Journal of Global Positioning Systems
|
JGPS Team Structure, Copyright and Table of Contents |
JGPS Team Structure, Copyright
|
1. Correlation Analysis for Fault Detection Statistics in Integrated GNSS/INS Systems |
|
Jinling Wang(1), Ali Almagbile(1), Youlong Wu(1) and Toshiaki Tsujii(2)
Global Satellite Navigation Systems (GNSS) have been widely used for positioning, navigation and timing. Therefore, the integrity of the satellite based navigation systems have been a major concern for many liability critical applications, such as civil aviation, and location-based services (LBS). Over the past two decades, GNSS Receiver Autonomous Integrity Monitoring (RAIM) procedures have been developed, but the efficiency of such procedures is highly dependent on measurement redundancy and geometric strength within the GNSS positioning solutions. Reliability of the system can be measured by, not only the well-known Minimal Detectable Biases (MDBs), but also the recently derived Minimal Separable Biases (MSBs) for the measurements. While the previous research has shown that the MSBs are directly related to the correlation between the faulty measurement detection statistics, comprehensive analysis for such correlations between fault (or outlier) detection statistics is still lacking, even for commonly used GNSS/INS integration scenarios. In this research, we have demonstrated that that with the aid of INS sensors, even with low-cost MEMS sensors, the MDBs and correlation coefficients between the measurement detection statistics can be significantly reduced, thus improving the separability of faults in GNSS measurements. |
2. SPOT GNSS in Emergency and Location Based Services |
|
Ali Sarwar, Binghao Li
Location Based Systems (LBS) market has emerged exponentially since early 2000 in the wake of growing need for Emergency Relief Applications. The argument of course outstanding is which device outperforms all other in diverse scenarios without failure. While many purpose built LBS are in use, SPOT satellite messenger gained attention for its reliability. This paper summates the system architecture and experimental tests results with those of competing Assisted and Global Navigation Satellite Systems (A/GNSS). Our test bed comprised of 26 test points with pre-established database of GNSS difficulty levels in diverse environments in UNSW. Parameters of interest are availability, accuracy and Time to First Fix (TTFF). Relative benchmarking proves SPOT's higher TTFF and higher failure rate in general. While High Sensitivity GNSS and Assisted GNSS (MS-Based and MS-Assisted) had higher availability, higher accuracy and lower TTFF. Altogether fewer failure scenarios, trustworthy coverage with cost effectiveness were observed for MS-Based AGNSS which is vital for LBS applications. However reliance on wired or wireless IP network potentially limits the performance in non-existent underlying infrastructure in remote applications. SPOT demonstrated higher TTFF and failure rates in test scenario. On the contrary Assisted GNSS (MS-Based or MS-Assisted) can provide a reliable, cost effective and open source alternative to SPOT satellite messenger with better TTFF, availability and accuracy for consumer and research applications. |
3. Improving GNSS CORS Design: The CORSnet-NSW Adjustable Antenna Mount (CAAM) |
|
Russell Commins and Volker Janssen
Global Navigation Satellite System (GNSS) Continuously Operating Reference Station (CORS) networks are being built and expanded around the world, contributing to the definition and realisation of geodetic reference frames as well as providing reliable and accurate positioning infrastructure for a wide range of applications. Depending on the purpose of the GNSS station, CORS antenna monuments typically vary from concrete pillars anchored to bedrock to masts attached to buildings. An antenna mount is used to connect the GNSS antenna to the monument. In all cases it is desired that the CORS antenna is oriented to True North in order to gain maximum benefit from GNSS antenna modelling. Other requirements generally include the unambiguous definition of the survey mark and Antenna Reference Point (ARP), and a zero or minimal antenna height. This paper introduces the CORSnet-NSW Adjustable Antenna Mount (CAAM), developed by NSW Land and Property Information (LPI) for CORSnet-NSW, LPI's rapidly growing GNSS CORS network covering the state of New South Wales, Australia. The CAAM was purposely designed to be incorporated into (rather than simply attached to) antenna masts located on buildings or free-standing pole monuments but can also be used for pillar monuments. Being free of removable parts, it is adjustable in order to orient the antenna to True North without introducing an antenna height, thereby allowing clear definition and maximum traceability of the survey mark and the ARP. LPI encourages adoption of the CAAM for use in other GNSS CORS networks. |
4. Evaluations on 3D Personal Navigation based on Geocoded Images in Smartphones |
|
Yiwu Wang(1), Ruizhi Chen(2,3), Yuwei Chen(2,4), Ling Pei(2), Hannu Hyyppä(1), Juha Hyyppä(4), Lingli Zhu(4), Kirsi Virrantaus(1)
3D personal navigation is becoming a standard feature in smartphone platform, which develops in a fast speed nowadays. However, the hardware restrictions of smartphone may degrade the 3D rendering performance, and such real-time operation is not an energy-efficient procedure on smartphone, because heavy computation consumes a lot of power, which is crucial for a smartphone equipped with limited capacity battery. This paper presents a novel solution utilizing geocoded images instead of 3D models to mitigate these technical restrictions on the smartphone. To demonstrate the performance and the improvement of the proposed solution, evaluations are carried out in term of positioning accuracy, resource consumption, efficiency, visualization, and labour costs. The results show that the proposed solution has overwhelming advantages in all these comparisons. This solution also has the capability of achieving a higher frame rate and has a better visualization performance as well. In addition, the proposed solution provides an optional way to decrease the labour costs and hardware investment to build up a similar but quick application by utilizing photos instead of complex 3D model construction for a small-scale area personal navigation application. |
5. A LabVIEW-Based GPS Receiver Development and Testing Platform with DSP Peripherals: Case study with C6713 DSK |
|
Arpine Soghoyan and David Akopian
The modernization of Global Positioning Systems (GPS) and the availability of more complex signals and modulation schemes boost the development of civil and military applications while the accuracy and coverage of receivers continually improve. Recently, software defined receiver solutions gained attention for flexible multimode operations. For them, developers address algorithmic and hardware accelerators or their hybrids for fast prototyping and testing high performance receivers for various conditions. This paper presents a new fast prototyping concept exploiting digital signal processor (DSP) peripherals and the benefits of the host environment using the National Instruments (NI) LabVIEW platform. With a reasonable distribution of tasks between the host hardware and reconfigurable peripherals, a higher performance is achieved. As a case study, in this paper the Texas Instruments (TI) TMS320C6713 DSP is used along with a Real Time Data Exchange (RTDX) communication link to compare with similar Simulink-based solutions. The proposed testbed GPS signal is created using the NI PXI signal generator and the NI GPS Simulation Toolkit. |
6. Performance Evaluation of EGNOS in Challenging Environments |
|
Jingbin Liu(1), Ruizhi Chen(2,1), Yuwei Chen(1), Tuomo Kröger(1), Ling Pei(1)
Space-based augmentation systems (SBAS), such as EGNOS, are largely used to complement GPS for accurate and reliable positioning, which is required by rapidly growing location-based services (LBS). However, it is challenging to use EGNOS in the environments including urban areas and marginal area of the monitoring networks, where many LBS are delivered. Through the experiments in the challenging observation conditions, this study first evaluates the performance of EGNOS in these environments. Challenges consist in two aspects: EGNOS signals may be interrupted by blockages; EGNOS messages are not produced at all for marginal geographical areas due to the lack of raw satellite measurements. In order to use EGNOS for enhanced positioning performance in these environments, this paper then discusses several potential solutions. It is concluded that the two autonomous approaches, i.e. using aged corrections and mixing corrected and uncorrected satellites, can improve the positioning accuracy with a stand-alone receiver, and a full EGNOS positioning performance can be achieved in urban areas via a terrestrial access to EGNOS data, for example, the Internet connection with a smartphone. This paper discusses the effectiveness and usability of these approaches. |
7. GNSS-based monitoring and mapping of shoreline position in support of planning and management of Matinhos/PR (Brazil) |
|
Rodrigo Mikosz Goncalves(1), Joseph Awange(2), Cláudia Pereira Krueger(3)
Monitoring and mapping variations in shoreline location is an activity that can be undertaken using several different techniques of data collection, e.g., photogrammetric restitution, satellite images, LiDAR (Light Detection and Ranging) or classical topographical surveys to support coastal environmental protection such as identifying flood risk areas. The global navigation satellite system (GNSS) has been employed by the Federal University of Parana (UFPR) as part of their research into the application of geodetic survey methods for shoreline mapping in coastal environments since 1996. The advantages of using GNSS are accuracy and productivity, given that a great number of points can be determined within a short period of time at decimeter-level accuracy. In this work, GNSS relative kinematic positioning approach was applied to monitor Matinhos coastal district of Brazil. Other important data, such as the high- and low-tide marks, all obtained using GNSS, and thematic maps have also been incorporated. Through the reanalysis of historical surveys, it is possible to make some conclusions about the shoreline dynamics and to use this information as material in support of the planning and management of the coastal environment, for example, when planning engineering works that set out to minimize coastal erosion and for urban planning. The results achieved in this work include defining the position of the shoreline for 2008, developing the thematic map of the shoreline, the quantification of the advance and retreat of the shoreline between 2001 and 2008, and a map showing those critical areas where the shoreline position is equal to the high-tide water line. GNSS-based method offers quicker, all-weather, highly accurate and continuously updatable shoreline positional time series relevant for monitoring, thus enabling quicker management decisions to be undertaken, which may be of benefit to coastal engineering applications. |
8. Analysis of Regionally Enhanced GPS Orbit and Clock Solutions and Contribution to Improvement of Real-Time Precise Point Positioning |
|
Charles Wang(1), Shengfeng Gu(2), Weixing Zhang(2), Chuang Shi(2), Yanming Feng(1)
This work experimentally examines the performance benefits of a regional CORS network to the GPS orbit and clock solutions for supporting real-time Precise Point Positioning (PPP). The regionally enhanced GPS precise orbit solutions are derived from a global evenly distributed CORS network added with a densely distributed network in Australia and New Zealand. A series of computational schemes for different network configurations are adopted in the GAMIT-GLOBK and PANDA data processing. The precise GPS orbit results show that the regionally enhanced solutions achieve the overall orbit improvements with respect to the solutions derived from the global network only. Additionally, the orbital differences over GPS satellite arcs that are visible by any of the five Australia-wide CORS stations show a higher percentage of overall improvements compared to the satellite arcs that are not visible from these stations. The regional GPS clock and Uncalibrated Phase Delay (UPD) products are derived using the PANDA real time processing module from Australian CORS networks of 35 and 79 stations respectively. Analysis of PANDA kinematic PPP and kinematic PPP-AR solutions show certain overall improvements in the positioning performance from a denser network configuration after solution convergence. However, the clock and UPD enhancement on kinematic PPP solutions is marginal. It is suggested that other factors, such as effects of ionosphere, incorrectly fixed ambiguities, may be the more dominating, deserving further research attentions
|
Corporate Members of CPGPS |
Corporate Members of CPGPS
|
Instructions to Authors |
Instructions to Authors
|
CPGPS Team Structure |
CPGPS Management Team (2012) Structure
|